Sewage or sump pump systems work using the gravity to move
solids and liquids down a line. These pumps are located in the basements of
homes and buildings. Their primary function is to act as an indoor septic
system. Generally, pumps are installed in particularly constructed sump pits.
Water flows into the sump pit through drains or by natural water migration
through the soil. This pump will mainly handle liquids; there will be times
when solids will also need disposed of though a system. Commercial pumps may be
capable to handle large size particle.
This type of pump has
to move solids and liquids between locations. A typical one will sit in a
sewage basin, which must naturally be in the lowest area of the location
needing drained. The pump is able of being submerged and will likely have to
deal with some fluids at almost all times. Pumps are frequently powered through
plugging them into an electrical socket that is close by and in some cases
there may even be a battery backup if the electricity should ever go out. This
pump needs routine maintenance and testing. The submersible pump is a preserved
waterproof pump that is let down into the sump pit, the hole that is used to
collect the water. Both sewage and sump pumps are powered by cords leading to
electrical outlets. The sewage pump is needed to pump the refuse from the
toilet out to the city or septic system.
A submersible sewage pump is located at the bottom of basin
or receptacle, such as a septic tank. The intake for that pump is located as
close to the floor of the basin as possible, often being found on the bottom or
near the bottom of the device. The goal is to empty as much of the solids and
liquids as possible out of the basin. Because some room must be left between
the floor and the pump, however, it is unlikely that total draining will ever
take place without manual intervention.
BLAIRS Sewage submersible pump is extensively used in dirty
water, designed mainly for industrial and civil fields, sewers, galleries,
excavation sites, wells, channels, underground car parks and architectural
operations. They are also recommended for draining dirty water in domestic and
civil sectors. There is usually a check valve on the release pipe that prevents
all the water in the discharge pipe from going back into the sump hole when the
pump is done pumping. If you are going to replace the sump pump it is a good
idea to replace the check valve. It’s usually near the sump crock lid and is
attached with stainless steel clamps and rubber connections.” It is also
important for your home inspector to test any overflow alarms and check the
charge on any battery backups that may be present.
BDS Engineering offers variety of Sewage, sump pumps with
the brand name BLAIRS, Damon and Grundfos. Provide complete water treatment
solutions based in New Delhi India.
Our offered sewage Pumps Includes: